USB Power Supply for the ACSI2STM
This little gadget will provide 5V and up to 200mA to your ACSI2STM card of any other small devices.
​​
This kit is a simple and compact way to power your external ACSI2STM card (or other similar devices).
It plugs into the cartridge power of any Atari ST, STF, STE, Mega ST, Mega STE, TT and Falcon030.
The 3D case will all Atari. The gaps around the case and your Atari case will depend of your model, but they will be less than 5mm.
Two USB ports supply 5V and up to 200mA. They are protected again short with an electronic fuse. This will prevent damaging your Atari in case you try to pull more than 200mA
The kit comes with the following:
- The PCB board ready to use
- The 3D case
- 2x screws to mount the PCB into the case
- A 1m long USB-C to USB-C cable or USB-A to USB-C cable
You will need a screw driver to assemble the kit. Very easy to assemble.
The USB ports will only provide 5V supply. No data.
You should not connect devices that require more than 200mA. It is not designed to charge a phone or power a Raspberry Pie, light or fan for example.
Power comes from the internal PSU of your Atari. This is why it is limited this way.
Can I charge a phone?
You can try. Because the current is limited, your phone will charge slowly.
​
USB-C version is flush with your Atari computer. USB-A version is a bit thicker due to the USB-C size.
If you are not sure which one you want, go for the USB-C version for a better fitting.
​
​
​
Some pictures of the kits:
